top of page

How to replace an LED light in your pool




If you have an SR SMITH fiberglass LED light in your pool or spa, you may need to replace the bulb at some point. Here are the steps to follow:


  • Turn off the power supply to the light and disconnect the wire from the transformer.

  • Remove the light from the wall fitting by unscrewing it counterclockwise. You may need a tool to help you loosen it.

  • Pull the light out of the water and place it on a dry surface. Be careful not to damage the waterproof cable.

  • Unscrew the bezel from the light housing and remove the lens and gasket.

  • Unscrew the old bulb from the light socket and discard it safely.

  • Screw in the new bulb of the same type and wattage. Do not touch the bulb with your bare hands as this may shorten its lifespan.

  • Replace the gasket and lens on the light housing and screw on the bezel. Make sure there are no gaps or leaks.

  • Push the light back into the wall fitting and screw it clockwise until snug. Do not over-tighten it as this may damage it.

  • Reconnect the wire to the transformer and turn on the power supply. Test the light and enjoy your pool or spa!


Comments


© 2020 by JH Consulting for CHP, Inc.

bottom of page